Page 1 of 1
Custom hull tips needed.
Posted: Sun May 25, 2014 9:58 am
by Voltion99
Hello, I've just recently noticed SL2 was out so I tried my hand at making a few ships, they're killar. The problem is I suck at custom hulls, so if anyone has any tips for a beginner it would be much appreciated.
Re: Custom hull tips needed.
Posted: Sun May 25, 2014 12:15 pm
by R4V3-0N
you planning to draw one from scratch or make one from existing parts?
Re: Custom hull tips needed.
Posted: Sun May 25, 2014 5:50 pm
by Voltion99
R4V3-0N wrote:you planning to draw one from scratch or make one from existing parts?
Here is what I have so far:
I used the rebel rigger and the federation scout gibs. I'm still haven't finished most of it, (Coloring, Shading, Gibs, and shaping)
Re: Custom hull tips needed.
Posted: Sun May 25, 2014 6:44 pm
by R4V3-0N
what program you are using? I do not want to give you tips that will be literally impossible or not efficient.
Re: Custom hull tips needed.
Posted: Sun May 25, 2014 6:52 pm
by Voltion99
R4V3-0N wrote:what program you are using? I do not want to give you tips that will be literally impossible or not efficient.
I use photoshop.
Re: Custom hull tips needed.
Posted: Mon May 26, 2014 3:51 am
by R4V3-0N
I think it would be better for one of the other forumers to help you out, I do not use photoshop (costs to much money
) and from the looks of things so far so good, you do need to work back into it a bit but besides that all is good, just keep working upon it. make sure to add the out line again to areas you cut off and stuff, etc. your recolouring seems to be fine, but you do need to add some shading it seems.